Table of Contents
Advertisement
FASCIA PANEL
INSTALLATION
The fascia panel sections are available in 53" and
24" heights and 43" and 49" widths. Custom fascia
panel heights can be special ordered. Fascia panels
must provide a smooth surface for the platform
edge to run against to prevent any shear or
obstruction hazards. They must be fastened beneath
the opening and adjacent to each other with no
overlapping or gaps between them.
The upper landing of a deck with an opening
underneath requires a fascia wall.
NOTE: It may be necessary to stud up the wall to give the
fascia panel something to fasten to.
Once the structure is in place, fasten the fascia
panel to it.
Use temporary power and the platform control box to
run the lift up and down to check for a horizontal gap
between the upper landing and the platform. The gap
must be no less than 3/8" and no greater than 3/4".
See Figure 4-28.
Figure 4-28
VPL400-X: SECTION 4
INSTALLING THE TOP
LANDING GATE
NOTE: If the call/send switch is installed in the gate, the
wires are routed between the gate and to the top of the
tower. If the call send is located outside the gate, the
wires are routed from the gate to the call send box and
then from the box to the top of the tower.
WARNING
!
The top of the gate must be attached to a
supporting structure. The gate is not designed to
be freestanding. Reference Typical Drawing ENG-
000847 Landing Gates.
WARNING
!
Disconnect all power before making any electrical
connections.
1.
Remove small screws and post cover on both
sides of the landing gate with a No. 1 Phillips
screwdriver.
2. Create the necessary space below the gate sill
so the wire can be routed into the gate post
through the wire routing slot in the bottom of
the gate mounting flange. See Figure 4-29.
Figure 4-29
VPL400-X:
21JULY2023 | 630-00159 B
INSTALLATION
Install Manual
19
Advertisement
Table of Contents
