Table of Contents
Advertisement
4. Open landing gate door and remove 4X hole
plugs.
5. Place the gate at the upper landing and center
the gate opening with the platform.
6. Use the holes in the gate threshold to screw
the gate down to the landing.
7. Run the wire through the wire routing slot and
to the interlock.
8. Cut the wire to length and strip the wire
conductors.
9. Connect the interlock wires and the gate call /
send switch (if equipped). See Figure 4-13.
Figure 4-13
NOTICE
The lift control board has a short circuit protection
feature that will disable landing circuits if the wires
are wired incorrectly. No landing functions will work
and all landing status lights will be OFF when in this
mode. Circuits will automatically reset when the
wiring is corrected.
10. Reinstall interlock, gate post covers, and hole
plugs.
NOTE: Gates are field reversible (contact Harmar
Technical Service for instructions).
FASCIA PANEL
INSTALLATION
The fascia panel sections are available in 53" and
24" heights and 43" and 49" widths. Custom fascia
panel heights can be special ordered. Fascia panels
must provide a smooth surface for the platform
edge to run against to prevent any shear or
obstruction hazards. They must be fastened beneath
the opening and adjacent to each other with no
overlapping or gaps between them.
The upper landing of a deck with an opening
underneath requires a fascia wall.
NOTE: It may be necessary to stud up the wall to give the
fascia panel something to fasten to.
Once the structure is in place, fasten the fascia
panel to it.
Use temporary power and the platform control box to
run the lift up and down to check for a horizontal gap
between the upper landing and the platform. The gap
must be no less than 3/8" and no greater than 3/4".
HIGHLANDER II VERTICAL PLATFORM LIFTS:
HIGHLANDER II: SECTION 4
INSTALLATION
Install Manual
17FEB2021 | 630-00113 REV C
17
Hide quick links:
Advertisement
Table of Contents
