Table of Contents
Advertisement
3. Using a #1 Phillips screwdriver remove the
interlock covers screws. See Figure 4-20.
Figure 4-20
4. Make interlock wire connections.
See Figure 6-2 on page 30.
5. If a right-hand platform gate is installed the
interlock harness must be routed through the
hole. See Figure 4-21.
Figure 4-21
VPL400-X: SECTION 4
6. Continue routing through the bottom tube
and out the other end. Install the rectangular
caps into the bottom gate tube. Create a small
notch in the rectangular cap to route the
harness through after it is installed.
See Figure 4-22.
Figure 4-22
7. Secure the platform interlock harness, control
box harness, and safety pan harness under the
carriage flange clip. See Figure 4-23.
Figure 4-23
8. Remove the platform gate jumper plug from
the trailing cable and plug the platform gate
interlock cable into the trailing cable.
VPL400-X:
21JULY2023 | 630-00159 B
INSTALLATION
Install Manual
17
Advertisement
Table of Contents
