Kvm Adapter Cables - ATEN KN1132VB Series User Manual

KVM Adapter Cables

 Cat 5e (or higher) cable is required to connect the KVM over IP switch to
the KVM Adapter Cables (see page 31).
 The following KVM Adapter Cables are required for use with the KVM
over IP switch:
Connect to devices with PS/2 ports
Connect to devices with USB ports
(All platforms – PC, Mac, Sun)
Connect to Sun Legacy Computers
Connect to serial based devices
For USB computers – DVI output, Virtual
Media and Smart Card Reader support
For USB computers – HDMI output, Virtual
Media and Smart Card Reader support
For USB computers – DisplayPort output,
Virtual Media and Smart Card Reader support
Connect to devices with USB ports and virtual
media support
Connect to devices with USB ports, virtual
media and audio support
Connect to devices with USB ports, with virtual
media, smart card reader support
For USB computers – VGA output, Virtual
Media, audio and dual output support
Connect to devices with USB-C port, with
virtual media support
For USB computers – HDMI output, Virtual
Media, Smart Card Reader, and audio support
For USB computers – DisplayPort output,
Virtual Media, Smart Card Reader, and audio
support
Note: If you use Adapter Cables purchased prior to your switch purchase, you
may have to upgrade the Adapter's firmware. (see page 224).
Function
Chapter 1. Introduction
Module
KA7120
KA7170
KA7130
KA7140
KA7166
KA7168
KA7169
KA7175
KA7176
KA7177
KA7178
KA7183
KA7188
KA7189
11