ATEN KN1132VB Series User Manual page 55

4. Connect the connectors on the KVM adapter into the appropriate ports on
the server you are installing.
5. Connect an Ethernet cable to the unit's primary LAN port.
6. (Optional) Connect another Ethernet cable to the unit's secondary LAN
port.
7. (Optional) Connect a serial adapter to the unit's PON port via a Cat 5e/6
cable, and then connect the adapter to the PON input port of a PDU unit.
8. (Optional) Connect a serial adapter to the unit's serial port via a Cat 5e/6
cable, and then connect the adapter's serial connector to the DB-9 port on
a PC or modem.
9. Plug the supplied power cord(s) to the unit's power socket (s), and then
into an AC power source.
Note:
 When using a single power socket, make sure to turn on the
correct power switch.
 When using both power sockets, either of the power switches can
be used to power on the unit, or turn on both power switches for
power redundancy.
10. Power on the KVM over IP switch, and then power on the computers,
displays, and the other connected devices.
Chapter 2. Hardware Setup
37