ATEN KN1132VB Series User Manual page 37

No. Component
1 grounding
terminal
2 power switches These standard slide switches power the unit on and off.
3 secondary LAN
port
4 PON port
5 KVM ports
6 power sockets
7 primary LAN
port
8 serial port
9 remote console
port
10 local console
port(s)
The wire used to ground the unit connects here.
The cable that connects the unit to the backup network
interface (10/100/1000 Mbps) plugs in here.
This connector is provided for a Power over the Net™
(PON) unit which allows servers attached to the KVM over
IP switch to be booted remotely over the net.
See KN2116VA / KN4116VA / KN1132V / KN2132VA /
KN4132VA / KN8132V / KN4164V / KN8164V / KN8116V
Single-Stage Installation on page 33, step 6 for installation
details. Contact your dealer for more information regarding
PON units.
The Cat 5e cables that link the unit to the KVM Adapter
Cables (which connect to the servers), plug in here.
The power cable(s) plugs in here. The left power socket
corresponds to the left power switch, and the right power
socket corresponds to the right power switch.
The cable that connects the unit to the primary network
interface (10/100/1000 Mbps) plugs in here.
This port can be used for a serial device; or for a dial in
connection should the unit be unavailable over the network.
See KN2116VA / KN4116VA / KN1132V / KN2132VA /
KN4132VA / KN8132V / KN4164V / KN8164V / KN8116V
Single-Stage Installation on page 33, step 7 for installation
details.
This port is reserved and will be available for use with future
upgrades as a remote console port.
The unit can be accessed via a local console as well as over
the Net. The local console devices (USB keyboard, USB
mouse, DVI-D or VGA monitor) plug in here.
Chapter 1. Introduction
Description
19