Table of Contents
Advertisement
HIGH-RES COLOR, FIXED LENS
FIXED AND FIXED VARI-FOCAL LENSES. There are no user
adjustable settings on these units (Figure 14)
AUTO IRIS LENSES: The auto iris can be adjusted if needed. See
the Troubleshooting section for instructions.
Figure 14
HIGH-RES COLOR & DAY/NIGHT w/AUTO-IRIS
NOTE: This hi-res color camera uses a 1/4" chip and a 3-6mm
auto iris lens. It is comparable to a 1/3" chip using a
4-9mm auto iris lens.
The operational settings are defined by four dip switches located on
the side of the PC Board (Figure 12 and 13). Moving the switches
to the UP position will activate specific settings. Refer to the chart
below.
Dip Switches
Figure 12
Figure 13
Dip Switch
UP
1
(Iris)
Auto Iris On
2
(Flickerless)
Shutter speed
fixed at 1/100 sec.
3 (Back Light
ON
Compensation
4
(Synch Mode)
Internal Synch
COMPLETION OF INSTALLATION
1. When the desired focus is achieved for each camera, adjust the
2. Reattach the dome by putting it in place, turning clockwise until it
Auto Iris
NVT INSTRUCTIONS
adjustment
screw
UNSHIELDED TWISTED PAIR
VIDEO WIRING
NOTE: The customer must purchase the Video Transceiver from
The cameras included in the Q-View™ series have the option of
transmitting video signals to NVT receivers via unshielded twisted
pair cable. You must purchase the receiver separately. Instructions
for connecting the receiver end of the the unshielded twisted pair
cable will be included with the NVT receiver. Following are instruc-
tions for connecting the unshielded twisted pair cables to the RJ45
(Cat. 5) cable running outside your housing.
Auto Iris
Adjustment
Screw
DOWN
2. Connect the other end of the unshielded twisted pair cable to the
Position for Fixed Lens
Normal
Normal
3. When using unshielded twisted pair cable you DO NOT need the
Line Lock Mode
- -
segmented bracket arms to the desired viewing angle. Once
you've finished, put the dome back in place and check to be sure
none of the cameras touch the dome. If one or more do,
readjust the arm(s) until they are clear of the dome.
locks, and then tightening the locking screws.
NVT. Part numbers are:
• NV-212A (500 ft.)
* NV-213A or NV-213A-M (1000 ft.)
• NV-652R, NV-862R, or NV-1662R (3000 ft.)
1. Video for all four cameras is contained in the one RJ45 (Cat. 5)
cable. An RJ45 female coupling is provided so that all connections
can be made with an RJ45 connector. The following is the wiring
diagram for the four twisted pair wires that are included with the
Cat. 5 cable.
PIN
WIRE COLOR
1
White/Green
2
Green
3
White/Orange
6
Orange
5
White/Blue
4
Blue
7
White/Brown
8
Brown
NVT receiver.
CAUTION: The unshielded twisted pair video signal is polarity
dependent. The positive video wire for each camera
MUST be connnected to the postitive terminal on the
NVT receiver, and negative MUST be connected to
negative.
BNC connector. All four BNC connectors are provided inside the
housing for testing purposes. Be sure that there is no video con-
nection other than the unshielded twisted pair cable.
CAMERA NUMBER
Camera 1 +
Camera 1 -
Camera 2 +
Camera 2 -
Camera 3 +
Camera 3 -
Camera 4 +
Camera 4 -
Advertisement
Table of Contents
