Installing Torch Remote - Kemppi Flexlite GXe Series Operating Manual

3.2 Installing torch remote

The Flexlite GXe series 5 welding torch remote (GRe50) is available as an optional accessory. GRe50 is not compatible
with series 8 GXe welding torches.
With the Flexlite GXe series 8 welding torches the torch remote GRe80 is delivered with the welding torch. Before
welding, the temporary protection plate must be removed from the welding torch and the torch remote installed.
The series 8 GXe welding torches incorporate the use of the additional control cable with X5 FastMig and Master M
(350 models) welding equipment. The series 8 welding torch remote does not work with series 5 welding torches.
Ensure that the welding equipment is not connected to the mains or that the welding torch is not connected at this
stage.
Tools needed:
TX20
1. Remove the cover by releasing the screws on the sides and then moving the cover slightly forward and up.
2. First set the torch remote control rear into the groove on the torch body and then press the remote control fully in
place so that the connectors align.
© Kemppi
9
Flexlite GXe
Operating manual - EN
1922260 / 2343