Installing Torch Remote - Kemppi FLEXLiTE TX Series Operating Manual

3. Prior to installing the tungsten electrode, grind the electrode tip to the appropriate dimensions for your weld-
ing application. For more information, refer to the section "Electrode tip" on page 14.
4. Push the electrode into the torch and through the collet and gas nozzle.
5. Install the electrode back cap. Tightening the back cap also locks the electrode in place.
Do not use excessive force. Overtightening may damage the torch components.
By loosening the electrode back cap, the electrode can be installed also by pushing it into the torch from the other
side.

3.2 Installing torch remote

Many Flexlite TX welding torches are equipped as standard with ON/OFF start/stop switches. Optional remote con-
trol devices can be fitted to these TX torch models, allowing both start/stop function and welding current adjust-
ment.
© Kemppi
7/24
Flexlite TX
Operating manual - EN
1920910 / 1921