Operation - Kemppi Flexlite GXe Series Operating Manual

4. OPERATION

Before using the equipment, ensure that all the necessary installation actions have been completed according to your
equipment setup and instructions.
Welding is forbidden in places where there is an immediate fire or explosion hazard!
Welding fumes may cause injury. Take care to ensure sufficient ventilation during welding and wear respiratory pro-
tection!
Always check before use that interconnecting cable, shielding gas hose, earth return lead/clamp and mains cable are
in serviceable condition. Ensure that the connectors are correctly fastened. Loose connectors can impair welding per-
formance and damage connectors.
The exact function of the torch and trigger may vary depending on your welding machine settings (e.g. 2T, 4T or
Minilog).
To start welding, press the trigger switch.
"Using torch remote GRe50 (series 5)" on the next page
"Using torch remote GRe80 (series 8)" on page 23
With the gas-cooled Flexlite GXe welding torches (G-models), the neck direction can be adjusted (360°) by turning it.
For more information on component selection and availability, refer to "Component selection" on page 42.
© Kemppi
21
Flexlite GXe
Operating manual - EN
1922260 / 2343