8.
Place the sleeve nut on the wire liner and secure it in place by tightening it to 5 Nm torque.
3.4.2 Replacing steel wire liner
Tools needed:
Removing and inserting wire liner
The visual details may vary slightly between different welding torch models. The method is the same for both gas- and water-
cooled welding torches.
1.
Straighten the welding torch cable.
2.
At the wire feeder end of the cable, remove the wire liner's sleeve nut.
© Kemppi
15
Flexlite GXe
Operating manual - EN
1922260 / 2343