Installing And Replacing Wire Liner; Replacing Dl Chili Wire Liner - Kemppi Flexlite GXe Series Operating Manual

3.4 Installing and replacing wire liner

The Flexlite GXe welding torch cable packs are delivered with the wire liner preinstalled. Refer to this section when the
wire liner needs to be replaced.
The wire liner is a consumable part, which needs to be changed if worn and when the filler wire material changes.
For replacing the steel wire liner, refer to "Replacing steel wire liner" on page 15.
For replacing the DL Chili wire liner, refer to "Replacing DL Chili wire liner" below.
If you change the filler wire to a different diameter or material, change also the feed rolls in the wire feed system
accordingly.
With most of the Flexlite GXe welding torch models both steel wire liner and DL Chili wire liner can be used.
The filler wire must be removed before the wire liner replacement. Always read the instructions delivered with the
replacement wire liner as well.

3.4.1 Replacing DL Chili wire liner

Tools needed:
Removing and inserting wire liner
The visual details may vary slightly between different welding torch models. The method is the same for both gas- and water-
cooled welding torches.
1. Straighten the welding torch cable.
2. At the wire feeder end of the cable, remove the wire liner's sleeve nut.
© Kemppi
12
Flexlite GXe
Operating manual - EN
1922260 / 2343