Sun Microsystems GigabitEthernet FC-AL/P Combination Adapter Installation Manual page 68

4. Type show-nets to display the list of devices.
You should see a list of devices, similar to the example below, specific to the Sun
GigabitEthernet/P adapter:
ok show-nets
a) /pci@1f,2000/pci@1/network@4
b) /pci@1f,4000/network@1,1
q) NO SELECTION
Enter Selection, q to quit: q
5. Type the following to run the selftest using the test command.
ok test device path
The following tests are run when the test command is executed:
SERDES internal loopback test
Link up/down test
If the test passes, you will see these messages.
ok test /pci@1f,2000/pci@1/network@4
Internal loopback test -- succeeded.
Link is -- up
If the card is not connected to a network, you will see the following messages.
ok test /pci@1f,2000/pci@1/network@4
Internal loopback test -- succeeded.
Link is -- down
6. After testing the adapter, type the following to return the OpenBoot PROM to
standard operating mode.
ok setenv diag-switch? false
7. Set the auto-boot? configuration parameter to true.
ok setenv auto-boot? true
50 Sun GigabitEthernet FC-AL/P Combination Adapter Installation Guide • March 2000