Defining The Current Status; Table 4-2 Read-Only Parameters Defining The Current Status - Sun Microsystems GigabitEthernet FC-AL/P Combination Adapter Installation Manual

TABLE 4-1
Parameter
adv_1000fdx_cap
adv_1000hdx_cap
adv_pauseTX
adv_pauseRX
1000autoneg_cap
1000fdx_cap
1000hdx_cap
asm_dir_cap
pause_cap
lp_1000autoneg_cap
lp_1000fdx_cap
lp_1000hdx_cap
lp_asm_dir_cap
lp_pause_cap

Defining the Current Status

The read-only parameters described in
interface. These parameters define the current status.
TABLE 4-2
Parameter
link_status
link_speed
link_mode
ge Driver Parameter, Status, and Descriptions (Continued)
Status Description
Read and write Operational mode parameter
Read and write Operational mode parameter
Read and write Operational mode parameter
Read and write Operational mode parameter
Read only PCS autonegotiation capability
Read only PCS full duplex capability
Read only PCS half duplex capability
Read only PCS ASM_DIR capability
Read only PCS Symmetric PAUSE capability
Read only Link partner autonegotiation capability
Read only Link partner capability
Read only Link partner capability
Read only Link partner capability
Read only Link partner capability
Read-Only Parameters Defining the Current Status
Description
Current link status
0 = Link down
1 = Link up
Valid only if the link is up
0 = Link is not up
1 = 1000 Mbps
Valid only if the link is up
0 = Half duplex
1 = Full duplex
Chapter 4 Configuring the GigabitEthernet Device Driver Parameters
explain the operational mode of the
TABLE 4-2
29