To Display The System Configuration Information - Sun Microsystems GigabitEthernet FC-AL/P Combination Adapter Installation Manual

To Display the System Configuration Information

Use the prtdiag -v command to list the configuration of the host system.
In the example below, a Sun GigabitEthernet FC-AL/P Combination adapter
(
network-pci108e,2bad
TABLE 3-1
# /usr/platform/sun4u/sbin/prtdiag -v
System Configuration:
(UltraSPARC-II 296MHz)
System clock frequency: 99 MHz
Memory size: 128 Megabytes
========================= CPUs =========================
Brd CPU Module
--- --- -------
0 0 0
========================= IO Cards =========================
Bus Freq
Brd Type MHz
--- ---- ----
0 PCI 33
0 PCI 33
0 PCI 66
0 PCI 66
No failures found in System
===========================
========================= HW Revisions =========================
ASIC Revisions:
---------------
PCI: pci Rev 4
PCI: pci Rev 4
Cheerio: ebus Rev 1
System PROM revisions:
----------------------
OBP 3.11.2 1998/04/20 15:37
18 Sun GigabitEthernet FC-AL/P Combination Adapter Installation Guide • March 2000
) is installed in the 66-MHz PCI slot of an Ultra 30 system.
prtdiag -v Command Output
Sun Microsystems
Run Ecache
MHz MB
----- ------
296 2.0
Slot Name
---- --------------------------------
1 network-SUNW,hme
3 scsi-glm/disk (block)
4 network-pci108e,2bad
5 SUNW,ifp-pci1077,2100.4/ssd (blo+
POST 1.1.1 1997/03/04 13:59
sun4u Sun Ultra 30 UPA/PCI
CPU CPU
Impl. Mask
------ ----
US-II 1.1
Model
----------------------
Symbios,53C875
SUNW,pci-gem