Sun Microsystems GigabitEthernet FC-AL/P Combination Adapter Installation Manual page 54

Using the ndd Utility in Interactive Mode
To modify a parameter value in interactive mode, specify ndd /dev/ge, as shown
below.
The ndd utility then prompts you for the name of the parameter:
# ndd /dev/ge
name to get/set? (Enter the parameter name or ? to view all
parameters)
After entering the parameter name, the ndd utility prompts you for the parameter
value (see
To list all the parameters supported by the ge driver, type ndd /dev/ge \?.
(See
# ndd /dev/ge \?
?
link_status
link_speed
link_mode
ipg1
ipg2
instance
lance_mode
ipg0
adv_1000autoneg_cap
adv_1000fdx_cap
adv_1000hdx_cap
adv_pauseTX
adv_pauseRX
1000autoneg_cap
1000fdx_cap
1000hdx_cap
asm_dir_cap
pause_cap
lp_1000autoneg_cap
lp_1000fdx_cap
lp_1000hdx_cap
lp_asm_dir_cap
lp_pause_cap
#
36 Sun GigabitEthernet FC-AL/P Combination Adapter Installation Guide • March 2000
through
TABLE 4-1
through
TABLE 4-1 TABLE 4-8
).
TABLE 4-8
for parameter descriptions.)
(read only)
(read only)
(read only)
(read only)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)