Configuring The Network Host Files; Displaying The System Configuration Information - Sun Microsystems GigabitEthernet FC-AL/P Combination Adapter Installation Manual

3
C H A P T E R

Configuring the Network Host Files

This chapter describes how to configure the system host files to use the Sun
GigabitEthernet driver software.
This chapter contains the following sections:
"Displaying the System Configuration Information" on page 17
"Configuring the Network Host Files" on page 19
"Setting up a Diskless Client System on a GigabitEthernet Network" on page 20
"Installing the Solaris Operating Environment Over a GigabitEthernet Network"
on page 22
Displaying the System Configuration
Information
Before editing the system host files, you may first want to view the output of the
prtdiag command. The prtdiag command displays the diagnostic and system
configuration information of the system. Using this command, you can display the
location of the installed PCI adapters.
Note – Refer to the prtdiag(1M) man page and the Solaris documentation for
more information about this command.
17