Figure 2-2 Removing The Dust Covers; Figure 2-3 Connecting A Cable To The Fc-Al Connector - Sun Microsystems GigabitEthernet FC-AL/P Combination Adapter Installation Manual

8. Applying even pressure at both corners of the adapter, push the PCI adapter until
it is firmly seated in the slot.
Caution – Do not use excessive force when installing the adapter into the PCI slot.
You may damage the adapter's PCI connector. If the adapter does not seat properly
when you apply even pressure, remove the adapter and carefully reinstall it again.
9. Secure the adapter to the PCI slot using the screw you removed in Step 6.
10. Detach the wrist strap and close the system unit.
11. Remove the dust covers from the adapter's fiber-optic connectors.
Dust covers
Removing the Dust Covers
FIGURE 2-2
12. Connect a fiber-optic cable to the FC-AL connector (
such as a disk array or a hub.
Refer to the documentation that came with the peripheral device for specific
instructions.
Connecting a Cable to the FC-AL Connector
FIGURE 2-3
FIGURE 2-3
FC-AL connector
Chapter 2 Installing the Adapter
) and to a device
11