Table of Contents
Advertisement
2. Set the parameters for the above devices in the kernel/drv/ge.conf file.
In the example below, the ipg1 and the ipg2 parameters are set for the three
GigabitEthernet devices.
name="pci108e,2bad" parent="/pci@4,4000" unit-address="4" ipg1=20 ipg2=10;
name="pci108e,2bad" parent="/pci@6,2000" unit-address="4" ipg1=20 ipg2=10;
name="pci108e,2bad" parent="/pci@4,2000" unit-address="4" ipg1=20 ipg2=10;
3. Save the ge.conf file.
4. Save and close all files and programs, and exit the windowing system.
5. Shut down and reboot the system.
Chapter 4
Configuring the GigabitEthernet Device Driver Parameters
39
Advertisement
Table of Contents
Need help?
Do you have a question about the GigabitEthernet FC-AL/P Combination Adapter and is the answer not in the manual?
Questions and answers