Operational Mode Parameters; Reporting Local Pcs Capabilities; Table 4-6 Operational Mode Parameters; Table 4-7 Read-Only Pcs Capabilities - Sun Microsystems GigabitEthernet FC-AL/P Combination Adapter Installation Manual

Operational Mode Parameters

TABLE 4-6
TABLE 4-6
Parameter
adv_1000autoneg_cap
adv_1000fdx_cap
adv_1000hdx_cap
adv_pauseTX
adv_pauseRX

Reporting Local PCS Capabilities

TABLE 4-7
parameters define the capabilities of the hardware. The GEM PCS supports all of the
following capabilities.
TABLE 4-7
Parameter
1000autoneg_cap
1000fdx_cap
32 Sun GigabitEthernet FC-AL/P Combination Adapter Installation Guide • March 2000
describes the operational mode parameters and their default values.
Operational Mode Parameters
Description
Local PCS capability advertised by the hardware
0 = Forced mode
1 = Autonegotiation (default)
Local PCS capability advertised by the hardware
0 = Not 1000 Mbit/sec full-duplex capable
1 = 1000 Mbit/sec full-duplex capable (default)
Local PCS capability advertised by the hardware
0 = Not 1000 Mbit/sec half-duplex capable
1 = 1000 Mbit/sec half-duplex capable (default)
Local PCS capability advertised by the hardware
0 = Not Pause TX capable (default)
1 = Pause TX capable
Local PCS capability advertised by the hardware
0 = Not Pause RX capable
1 = Pause RX capable (default)
describes the read-only Physical Code Sublayer (PCS) capabilities. These
Read-Only PCS Capabilities
Description (Local PCS Capabilities)
0 = Not capable of autonegotiation
1 = Autonegotiation capable
Local PCS full-duplex capability
0 = Not 1000 Mbit/sec full-duplex capable
1 = 1000 Mbit/sec full-duplex capable