Table of Contents
Advertisement
Installation Manual
2.5. Pre-Installation Safety Check
• Check for transport damages.
• Before connecting the product to the power supply, check the power supply voltage and current
rating corresponds with the power supply details shown on the product rating label.
DANGER
CAUTION RISK OF DAMAGE TO THE EQUIPMENT
CAUTION RISK OF DAMAGE TO THE EQUIPMENT
CAUTION RISK OF DAMAGE TO THE EQUIPMENT
The charger must be installed only by a licensed electrician in accordance with
the provisions of the local electrical industry construction and should comply with
National Electrical Codes and standards.
Before installing the charger, make sure you have read all of these instructions in
this manual and fully understand its contents.
Appropriate protection is required when connecting to a main switchboard. The
tools and parts used as outlined in the section "Tools & parts required for installa-
tion".
2.6. Grounding instructions
The charger must have equipment grounding through a permanent wiring system
or an equipment grounding conductor. Use a wire with a dedicated grounding
wire and a ring terminal and connect to the equipment ground terminal block for
grounding.
RISK OF SUFFOCATION
Keep any packing materials away from children – these materials are
a potential source of danger, e.g. suffocation.
Disconnect the power supply before installing or repairing the charger.
Failure to do so may result in physical injury or damage to the power
supply system and the charger.
Avoid touching or pressing the LCD screen, as this may result in damage
to the LCD screen.
Do not use extension cord sets.
80A Charging Station Series 2
13
Advertisement
Table of Contents
