Table of Contents
Advertisement
80A Charging Station Series 2
4.3. Ethernet Cable Installation
Ethernet can be used if there is no cellular or WIFI connection. Connect an ether-
net cable to the charger through grommet.
NOTE
Do NOT remove the grommets. Instead, let Ethernet cable pass through the
grommets.
Use tools to combine the RJ45 connector with RJ45 Cable. By using this
method, the IP level could be ≥IP55. The Erthernet cable diameter should be
3.5mm - 5mm.
Figure 4.14 Rotary Switch Configuration
Figure 4.15 Input Wiring Position
1 1
2
2
26
Installation Manual
Advertisement
Table of Contents
