Table of Contents
Advertisement
Installation Manual
2.
Fasten charger on mounting bracket by tightening M6 screw.
3.
Refer to the following screw torque guide.
Screw
M6
Step 6.
Stick the Amperage Reduction Label on the Charger
If you need to set your charger's current lower than the max. rating, use the label
corresponding to your selected current value from the amperage reduction label.
1.
The rotary switch label sticker is on the installation cover.
Figure 4.8 Fasten M6 Screw
Figure 4.9 Stick Label to Interior Install Cover
80A Charging Station Series 2
Torque
31 kgf.cm
21
26.9 lbf·in
Advertisement
Table of Contents
