Table of Contents
Advertisement
80A Charging Station Series 2
Screw sizing suggestion:
•
For masonry walls, use M6 mechanical screws. (Commercially Available)
•
For finished walls supported by wood studs, use #12 tapping screws.
•
Refer to the following screw torque guide. The actual torque is according to the wall
material.
Screw
M6
#12
Step 5.
Fasten Charger onto Mounting Bracket
1.
Put the charger on the mounting bracket.
Figure 4.7 Secure Charger to Mounting Bracket
Torque
25 kgf.cm min
25 kgf.cm min
20
Installation Manual
21.7 lbf-in min
21.7 lbf-in min
Advertisement
Table of Contents
