Table of Contents
Advertisement
44
REMOVING AND CARRYING THE OUTBOARD MOTOR
ENOW00073-A
Be sure to disconnect fuel connector except
when operating engine.
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
ENOW00952-0
When transporting, keep tank secured in
an upright position with the tank valve
turned off.
Do not use, store or transport tank where
it would be exposed to high tempera-
tures.
8
ENOW00071-0
The tilt support device supplied on your out-
board motor is not intended for towing. It is
intended to support the outboard motor
while the boat is docked, beached, etc.
ENOW00072-A
When trailering the outboard motor should
be in a vertical (normal running) position,
fully down. Trailering in the tilted position
may cause damage to the outboard motor,
boat, etc.
If trailering with outboard motor fully down
is not available (the gear case skeg is too
close to the road in a vertical position), fix
the outboard motor securely using a device
WARNING
ENOF00075-A
WARNING
CAUTION
CAUTION
(like a transom saver bar) in the tilted posi-
tion.
When transporting a boat on a trailer
with the outboard motor still attached,
disconnect the fuel line from the out-
board motor beforehand and keep the
outboard motor in the normal running
position or on a transom saver bar.
Tiller handle type
While transpor ting outboard motor
attached to the boat on a trailer, properly
tighten the steering friction bolt to pre-
vent the outboard motor from moving
(page 45).
1. Ground clearance should be provided
sufficiently.
2. Transom saver bar
ENOW00067-0
WARNING
Do not go under outboard motor tilted up
even if it is supported by support bar, or
accidental fall of outboard motor could lead
to severe personal injury.
2
1
ENOF00074-B
Advertisement
Table of Contents
