Battery Installation - TOHATSU MFS 6BZ Owner's Manual

24
INSTALLATION
1
2
1. Bolt (8 × 85)
5 2. Washer
3. Nylon locking nut
ENOW00008-2A
Tighten the bolts securely, otherwise the
outboard motor could fall down.
2
3
ENOF00507-2
ENOF00508-0
CAUTION
ENON00003-2
Notes
1. Apply sealing material, such as silicone
sealed between the bolts and the tran-
som board holes before tightening the
bolts.
2. For EP / EFT type, drill the holes in
transom board only at left and right of
lower side of clamp bracket, and
attach outboard motor with supplied
bolts.
For EPT type, drill the holes in transom
board at 4 points up and down, right
and left, and attach outboard motor
with supplied bolts.
Do not reuse Nylon locking nut.
ENOM00029-A

2. Battery installation

ENOW00012-1
WARNING
Battery electrolyte contains sulfuric acid
and is hazardous, causes a burn if come in
contact with your skin, and poisonous if
swallowed.
Keep batter y and electroly te away from
reach of children.
When handling the battery, be sure to:
Read all warnings shown on the battery
case.
Prevent electrolyte from coming in con-
tact with any part of your body. Contact
can cause serious burn or, if come in con-
tact with your eye, loss of sight. Use
safety glasses and rubber gloves.
In case you came in contact with battery
electrolyte:
For skin, flush thoroughly with water.
For eye, flush thoroughly with water, and
then seek immediate medical treatment.
In case battery electrolyte is swallowed:
Seek immediate medical treatment.