Table of Contents
Advertisement
20
INSTALLATION
ENOM00860-0
Remote control cable length
ENOW00100-A
Be careful not to loop the remote control
cables to a diameter of 406 mm (16 inches)
or less. Otherwise, it affects the service life
of the cable.
5
Measure the distance from the remote
control box to the outboard motor where
the remote control cable should be
routed.
Prepare a cable that is 300-450mm (11.8-
17.7in) longer than the measured dis-
tance.
Temporarily pull the cable along the
intended cable route to check its length
is sufficient.
Connect the remote control cable to the
engine, then run the cable to the remote
control box, making sure it is not sharply
bent, too taut and free from obstructions
that could interfere with steering.
CAUTION
ENOF00842-0
ENOM00029-A
3. Battery installation (For SP
model)
ENOW00012-0
WARNING
Battery electrolyte contains sulfuric acid
and thus is hazardous, causing a burn if it
comes in contact with your skin, or poison-
ous if swallowed.
Keep batter y and electroly te away from
reach of children
When handling the battery, be sure to:
Read all warnings shown on the battery
case
Prevent electrolyte from coming in con-
tact with any part of your body. Contact
can cause serious burn or, if it comes in
contact with your eye, loss of sight. Use
safety glasses and rubber gloves.
In case battery electrolyte comes in contact
with:
Skin, flush thoroughly with water.
Eye, flush thoroughly with water, and then
seek immediate medical treatment.
In case battery electrolyte is swallowed:
Seek immediate medical treatment.
ENOW00013-B
WARNING
Battery generates explosive hydrogen gas.
Be sure to:
Charge the battery in a well-ventilated
place.
Place the battery away from any source of
fire, sparks and open flames such as
burners or welding equipment.
Do not charge the battery when the elec-
trolyte level is low. Otherwise, the bat-
ter y will be damage d and may cause
malfunction.
Advertisement
Table of Contents
