Eneo IN Series Full Manual page 52

Maintenance
No. Item
1 Maintenance
2 Upgrade
3 Backup
4 Restore
5 IV License
6 Optics
52
Description
Restart
The unit is restarted without changing any of the settings. Use this method if the unit is not behaving as expected.
Reset
The unit is restarted and most current settings are reset to factory default values. The settings that are not affected are:
(the boot protocol (DHCP or static), the static IP address, the default router, the subnet mask, the system time)
Default
The Default button should be used with caution. Pressing this will return all of the network camera's settings to the factory
default values (including the IP address).
Upgrade your camera by importing an upgrade file from PC and pressing the Upgrade button. During the upgrade, do not
turn off the power of the network camera. Wait at least five minutes and then try to access the camera again.
Save the setting values that users have entered to the network camera to a user PC.
Import and apply a setting value previously saved to a user PC.
Backup and Restore can only be used on the same unit running the same firmware. This feature is not intended for
multi-configurations or for firmware upgrades.
Import and apply Intelligent Video analytics license file.
Calibrate focus and zoom.
This menu appears for motorized lens model only.