Eneo IN Series Full Manual page 36

FTP & JPEG
When the network camera detects an event, it can record and save images to an FTP server. Images can
be sent as e-mail attachments. Check the Enable FTP box to enable the service. This camera can support
multiple FTP servers and user can configure each server settings separately.
No. Item
1 FTP Setting
2 JPEG Setting
3 Save/Reset
36
Description
Server
Enter the server's IP address or host name. Note that a DNS server must be specified in the TCP/IP network settings if using
a host name.
Port
Enter the port number used by the FTP server. The default is 21.
Passive mode
Under normal circumstances the network camera simply requests the target FTP server to open the data connection.
Checking this box issues a PASV command to the FTP server and establishes a passive FTP connection, whereby the
network camera actively initiates both the FTP control and data connections to the target server. This is normally desirable
if there is a fire- wall between the camera and the target FTP server.
Remote directory
Specify the path to the directory where the uploaded images will be stored. If this directory does not already exist on the
FTP server, there will be an error message when uploading.
User name/Password
Provide your log-in information
Anonymous login
Check the box if you want to use anonymous login method and the server supports it.
Time type
The name of the folder where the uploaded image will be saved can be set as the date, time, and minute of the event.
Pre-event
A pre-event buffer contains images from the time immediately preceding the event trigger. These are stored internally in
the server. This buffer can be very useful when checking to see what happened to cause the event trigger. Check the box to
enable the pre-trigger buffer, enter the desired total length in seconds, minutes or hours, and specify the required image
frequency.
Post-event
This function is the counterpart to the pre-trigger buffer described above and contains images from the time immediately
after the trigger. Configure as for pre-even.
Prefix file name
This name will be used for all the image files saved. If suffixes are also used, the file name will take the form <prefix>
<suffix>.<extension>
Additional suffix
Add either a date/time suffix or a sequence number, with or without a maximum value.
When the settings are complete, click Save button to save the settings, or click Reset button to clear all of the information
you entered without saving it.