Eneo IN Series Full Manual page 35

Event Out
SMTP (E-Mail)
The network camera can be configured to send event and error email messages via SMTP (Simple Mail
Transfer Protocol).
No. Item Description
Enable SMTP
Select Enable SMTP to activate the SMTP operation.
Sender
Enter an email address to be used as the sender for all messages sent by the network camera.
Interval
Represents the time interval of the email notification when events occur several times.
Aggregate events
Shows the maximum number of emails sent within each interval.
1 SMTP (E-Mail) Setting Use Mail Server
Check the box if you are using a mail server to receive event notification and image email.
• Mail Server: Enter the host names (or IP addresses) for your mail server.
• Port: Enter the port number for your mail server.
• Connection security: Select a connection security type in the drop-down. (None / Start TLS / SSL)
• Enable use (SMTP) authentication: Check the box if your mail server requires authentication.
• User name/Password: Enter the User name and Password as provided by your network administrator or ISP (Internet
Service Provider).
• Login method: Choose a log-in method in the drop-down (AUTH LOGIN / AUTH PLAIN)
Receiver #
2 SMTP (E-Mail) Receiver User can assign up to 8 receivers
Enter an email address.
Receiver
User can check the SMTP setting via a sample email.
3 SMTP (E-Mail) Test
Enter an email address and click the Test button to test that the mail servers are functioning and that the email address is
valid.
When the settings are complete, click Save button to save the settings, or click Reset button to clear all of the information
4 Save/Reset
you entered without saving it.
EN
35