Eneo IN Series Full Manual page 50

RTP
Create a setting for sending and receiving an audio or video on a real-time basis. These settings are the
IP address, port number, and Time-To-Live value (TTL) to use for the media stream(s) in multicast H.264
format. Only certain IP addresses and port numbers should be used for multicast streams.
No. Item
1 Port Range
Multicast
(Stream1/ Stream2/
2
Stream3/ Stream4/
Audio/ Meta)
3 Save/Reset
50
Description
Start/End port: Enter a value between 30000 and 39760.
This function is for sending Video and Meta Data to Multicast group.
• Multicast destination IP:
Enter an IP between 224.0.0.0 and 239.255.255.255.
• RTP port
Enter a value between 1024 and 65532.
• RTP TTL
Enter a value between 1 and 255. If a network status is smooth, enter a lower value. However, if a network status is poor,
enter a higher value. When there are many network cameras or users, a higher value may cause a heavy load to the
network. Consult with a network manager for detailed information.
Always enable multicast
Check the box to start multicast streaming without opening an RTSP session.
When the settings are complete, click Save button to save the settings, or click Reset button to clear all of the information
you entered without saving it.