DFI RC300H-CS111 User Manual page 44

NCT6116D Super IO Configuration
TThis section is used to configure the I/O functions supported by the onboard Super I/O chip.
Aptio Setup Utility - Copyright (C) 2021 American Megatrends, Inc.
Advanced
NCT6116D Super IO Configuration
NCT6116D
Super IO Chip
WatchDog Timer Unit [Second]
0
SuperIO WatchDog Timer
Serial Port 1 Configuration

Serial Port 2 Configuration

Serial Port 3 Configuration

Serial Port 4 Configuration

Version 2.20.1275. Copyright (C) 2021 American Megatrends, Inc.
WatchDog Timer Unit
Select WatchDog Timer Unit: Second or Minute.
SuperIO WatchDog Timer
Set SuperIO WatchDog Timer Timeout value. The range is from 0 (disabled) to 255.
► Serial Port 1/2/3/4 Configuration
Configure the parameters of serial port 1 (COM 1) to serial port 4 (COM 4) as detailed
later.
RC300-CS
WatchDog Timer Unit
Selection
Select Screen
→←:
Select Item
↑↓:
Enter: Select
+/ - : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
44
► Serial Port 1/2/3/4 Configuration
Aptio Setup Utility - Copyright (C) 2021 American Megatrends, Inc.
Advanced
Serial Port 1 Configuration
Serial Port [Enabled]
Device Settings IO=3F8h; IRQ=4;
[RS232]
Electrical Interface Mode
Version 2.20.1275. Copyright (C) 2021 American Megatrends, Inc.
Serial Port
Enable or disable the serial COM port.
Electrical Interface Mode
Determine the electrical interface mode.
Enable or Disable Serial
Port (COM)
Select Screen
→←:
Select Item
↑↓:
Enter: Select
+/ - : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
www.dfi.com