DFI RC300H-CS111 User Manual page 48

USB Power Control
Configure USB port power voltage.
Aptio Setup Utility - Copyright (C) 2021 American Megatrends, Inc.
Advanced
USB2_1/2/ USB3_1/2 [5V_Dual]
USB2_3/4 USB3_3/4 [5V_Dual]
USB2_5/6 [5V_Dual]
Version 2.20.1275. Copyright (C) 2021 American Megatrends, Inc.
USB3_1/2/3/4&USB2_1/2/3/4/5/6
Select the power voltage for USB 1-8 — 5V_Dual or 5V.
RC300-CS
Network Stack Configuration
This section is used to configure the Network Stack settings.
5V_Dual: Support system
wake up from S3/S4 by
USB KB&MS
5V: No support system
wake up from S3/S4 by
USB KB&MS
Select Screen
→←:
Select Item
↑↓:
Enter: Select
+/ - : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
48
Aptio Setup Utility - Copyright (C) 2021 American Megatrends, Inc.
Advanced
Network Stack [Enabled]
Ipv4 PXE Support [Disabled]
Ipv6 PXE Support [Disabled]
PXE boot wait time 0
Media detect count 1
Version 2.20.1275. Copyright (C) 2021 American Megatrends, Inc.
Network Stack
This section is used to enable or disable UEFI network stack. When Network
Stack is enabled, the following fields will appear.
Ipv4 PXE Support
Enable or disable IPv4 PXE boot support. If disabled, IPv4 PXE boot support will
not be available.
Ipv6 PXE Support
Enable or disable IPv6 PXE boot support. If disabled, IPv6 PXE boot support will
not be available.
PXE boot wait time
Set the wait time in seconds to press ESC key to abort the PXE boot. Use either
+/- or numeric keys to set the value.
Media detect count
Set the number of times the presence of media will be checked. Use either +/-
or numeric keys to set the value.
Enable/Disable UEFI
Network Stack
Select Screen
→←:
Select Item
↑↓:
Enter: Select
+/ - : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
www.dfi.com