Attaching The Connector Locking Collar - Raymarine RV-100 Installation Instructions Manual

7. Tilt the transducer so that the bottom face of the transducer will be
parallel with the waterline and tighten the nut and bolt until the transducer
is held firmly in place.

5.4 Attaching the connector locking collar

The supplied cable is provided with a separate locking collar assembly,
ensuring that the cable connection is secure.
This procedure describes how to attach the locking collar to the cable
connector. The locking collar parts are supplied in a separate bag, in the
package with your product.
Important:
Ensure that you route the cable all the way to its destination before
attaching the locking collar.
24
1. Slide the locking collar over the end of the connector, then push it
towards the cable-end of the connector. Ensure that the lugs on the
locking collar (labelled 'A' in the illustration), are closest to the plug-end of
the connector.
2. Slide the split-ring over the end of the connector, then push it towards the
cable-end of the connector. Ensure that the tabs on the split-ring (labelled
'B' in the illustration), are closest to the cable-end of the connector.
The split-ring slides easily for approximately 1 cm (0.39 in) onto the
connector, before butting up against the connector moulding.
3. Carefully insert the pointed end of the supplied tool into the split-ring's
gap (labelled 'C' in the illustration). Use the tool to gently lever the split
ring over the moulding on the connector until it snaps into position