Mounting The Transducer - Raymarine RV-100 Installation Instructions Manual

5.3 Mounting the transducer

The transducer is mounted to the mounting bracket using the supplied nut
and bolt.
Important:
• Only perform the installation with your vessel out of the water.
• Do NOT lift or suspend the transducer using its cable.
• Do NOT overtighten the bolt. Overtightening may cause damage to
the transducer.
Note:
The screw located on top of the transducer is used when connecting the
transducer to a mounting adaptor such as the Step mount bracket (A80479).
You do not need to adjust this screw for transom mount installations.
Mounting
1. Ensure that the plastic chock (marked 'A' in the illustration) is positioned
in front of the transducer cable. If it is not, push the chock into the correct
position, aligning the hole in the chock with the holes in the transducer.
2. Position the transducer between the arms of the mounting bracket.
3. Align the hole in the transducer with the holes in the mounting bracket.
4. Slide the mounting bolt through the holes.
5. Screw the flanged nylock nut onto the end of the mounting bolt.
6. Tighten the nut onto the mounting bolt, using 2 x 14 mm wrenches or
adjustable wrenches, until the transducer is secure, but can still be
adjusted (tilted) by hand.
23