Table of Contents
Advertisement
1. Suggested Maintenance Tools
The following tools are suggested for routine maintenance work:
A set of 1.5-6mm hex (Allen) keys , Phillips head screwdriver (large, medium, small),
small tweezers, clean gauze, clean cotton swabs, clean brush, rubber gloves, 75%
alcohol and cleaning fluid, etc.
2. Daily Maintenance
Daily maintenance is recommended after daily use. The specific operation steps are
as follows:
a. After daily use is completed, power off the instrument and remove the samples,
reagents and consumables from the platform.
b. Properly dispose of any used pipette tips and waste liquids, according to
laboratory regulations or local regulations.
c. Keep the platform clean. There should be no residual liquids or stains on the
platform or in the rectangular indentations. If there is liquid residue, use paper
towels to absorb any liquids, and then wipe and clean the platform with a clean
soft cloth. Use 75% alcohol on a clean soft cloth to wipe and disinfect the platform
and any other surfaces that require cleaning.
d. When the instrument is not in operation for a long period, unplug it, and cover it
with dust cover.
3. Regular Maintenance
In addition to daily maintenance, regular maintenance is required after the instrument
has been operating for 6 months or has been in storage for a long period.
a. Run a typical program without any consumables installed to check that the
motors and tracks (X and Z axis) are operating smoothly. Check that the
platform the guide rail is well lubricated and there is no dust and impurities on
the guide rail. If found, please clean it up in time.
b. Check that all the moving parts are not making any abnormal noises and that
all screws are tight. If any screws have become loose, please tighten them.
Chapter 6 Maintenance
36
Advertisement
Table of Contents
