Troubleshooting - PROLiNK INSPIRE 703SFC User Manual

6 Storage and Maintenance
When replace the batteries, install the same number and same type of batteries.
Do not attempt to dispose of batteries by burning them. This could cause battery
explosion. The batteries must be rightly deposed according to local regulation.
Do not open or destroy batteries. Escaping electrolyte can cause injury to the skin
and eyes. It may be toxic.
Do not disassemble the UPS system.
7

Troubleshooting

Use the table below to solve minor problems.
PROBLEM
No LED display on
the front panel
Alarm continuously
sounds when the
main is normal
When power
fails, back-up
time is
shortening
The main is normal
but LED is flashing
POSSIBLE CAUSE
Low battery
Battery fault
The UPS is not turned on
The UPS is overload
The UPS is overload
Battery voltage is too low
Battery defect. It might
be due to high
temperature operation
environment or improper
operation to battery
Power cord is loose
SOLUTIONS
Charge the UPS at least 6 hours
Replace the battery with the same type
of battery
Press the power switch again to turn on
the UPS
Remove some loads first. Before
reconnecting equipment, please verify
that the load matches the UPS
capability specified in the specs.
Remove some critical load
Charge the UPS at least 6 hours
Replace the battery with the same
type of battery
Reconnect the power cord properly
EN8