PROLiNK INSPIRE 703SFC User Manual page 7

Connect the Loads
Plug in the loads to output receptacles on the rear panel of the
UPS. Simply turn on the power switch of UPS unit, and then
devices connected to the UPS will be protected by UPS unit.
CAUTION:
NEVER connect a laser printer or scanner to the UPS unit. This may cause the damage of the unit.
Data Line Surge Protection
(Only for the model with RJ11/RJ45)
Connect a single network/telephone/fax line into surge-protected "IN" outlet on the back
panel of the UPS unit. Connect from "OUT" outlet with another network/telephone/fax line
cable.
Connect Communication Cable
(Only for the model with USB port)
To allow for unattended UPS shutdown/start-up and status monitoring, connect the
communication cable one end to the USB port and the other to the communication port of
your PC. With the monitoring software installed, you can schedule UPS shutdown/start-up
and monitor UPS status through PC.
Turn On/Off the Unit
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit by pressing again
the power switch.
EN6