Removing The Top And Side Panels; Removing The Shield; Shield Securing Screws - HP 8133A Service Manual

Removing the top and side panels

Removing the shield

1. Remove the four plastic feet on the rear of the instrument.
2. Loosen the screw found in the middle of the
cover and slide the panel to the
3. Remove the carrying handle (on left panel
faces you) by unscrewing its two securing nuts and removing the
retainers at each end of the handle. Slide the left panel backwards
to remove it.
Remove right side panel by loosening the screw in the middle of its
4.
rear flange arid sliding the panel backwards.
remove all screws
in these recesses
Figure 5-5. Shield securing screws
the front of the instrument facing you, remove the six screws
1. With
along the riglit edge of the shield and one on the rear edge.
2. Removing the seven screws located in the upper channel of the
upper left frame strut, see Figure 5-5.
Do not lift the shield at too great an angle. Do not force the shield or
the assembly under it may be damaged.
3. Turn the right side of the pulse generator towards you and lift the
shield's right edge at a slight angle. With your thumbs along the
top of the shield apply pressure to it with the heels of your palms.
If the shield is held at the correct angle it should then pull out
towards you.
rear flange of the top
rear
to remove it.
as front of instrument
these screws
remove
/
I
b
0 '