Testing Tlhe H P 8133A Pulse Generator; Recommended Test Eauidment And Accessories - HP 8133A Service Manual

Recommended Test Equipment and Accessories
Use the tests in this chapter
Pulse Generator is working correctly. Before starting any testing:
Recall the HP 8133A Pulse Generator Standard Settings from
Memory
Let the H P 8133A Pulse Generator and all other test equipment
warm up for at least 30 minutes.
The tests are divided into the following sections:
Applies to
Applies to all instruments
Applies to each Output Channel. The tests in this
section need to be repeated for both channels in
a dual channel instrument. Not all the tests apply
to both
Table 3-3.
Within each section carry out the tests in the order given.
All tests which test the instrument against its warranted specifications
are called Performance tests, and the results can be recorded on the
Performance Test Record at the end of the chapter.
The Verification tests verify the instrument's non-warranted
characteristics.
The tables list the recommended test equipment you
following
to carry out all the tests in this chapter. Y o u can use alternative
instruments as long as they meet the critical specifications given. The
test set-ups and procedures assume you are using the recommended
equipment.
you want to check that the HP 8133A
if
all instruments.
and Channels, see
Testing HP 813311 Pulse Generator 3-1
the
need