Table of Contents
Advertisement
Fig. 54 Cable gland nut assembly
More than one cable can pass through low voltage cable gland.
5.5.1
Installer connections
Control panel access
▶ Release the latches from side panels [1] and hinge open [2] the
control panel into service position.
1.
Fig. 55 Moving control panel into service position
Greenstar 1000 – 6721835943 (2023/08)
0010042682-001
1.
2.
0010046005-001
Connect external accessories
Low Voltage (signal cable) accessories connections.
▶ Release the latches (1) by using fingers. Arrows on the service cover
indicate the position where the fingers must be inserted to release
the latches.
▶ Open the service cover by rotating lifting upwards (2).
1.
Fig. 56 Open the cover
▶ For splash protection (IP): Cut the strain relief according to the
diameter of the cable.
Care should be taken not to damage cables when cutting strain relief.
Remove the strain relief before cutting.
Fig. 57 Cable feed
▶ Guide the cable through the strain relief.
▶ Connect the cable to the removable PCB edge connectors.
▶ Secure the strain relief to the control unit.
Installation
1.
2.
0010042666-001
0010042667-001
39
Advertisement
Table of Contents
