Table of Contents
Advertisement
Installation
Mains cable routing
▶ Mains supply cable must be routed through either of the rubber
grommets in the frame assembly at the left-hand rear of the
appliance Figure 50.
Fig. 50 Mains supply cable routing
[1]
2 x left-hand rear grommets
[2]
Mains cable strain relief
Installation of cable grommets
Product has cable grommets under the appliance to pass through
cables. All cable grommets ensure soundness of product. So cable
grommets installed at factory either with closed seal or dust plug.
The appliance is factory-fitted with cable grommets as pictured below.
This is to ensure combustion seal soundness. When running cables
through the cable grommets please ensure the following instructions are
followed.
1
3-6,5
2
4-8
Fig. 51 Cable diameters (in mm)
[1]
Low voltage (signal cables) cable grommets
[2]
Power supply cables (mains and 230V controls)
38
1
1
Fig. 52 Cable gland parts
2
[1]
Locking nut
[2]
Body
[3]
Sealing grommet
[4]
Sealing nut
NOTICE
0010042664-001
Cable gland sealing grommets are included within the cable gland
when dispatched from the factory. There should be no
circumstances where sealing grommets need to be removed from
the cable gland.
Before you begin:
▶ Switch off all electrical equipment and disconnect any live wires.
▶ Do not damage loose entry wires during installation.
Installation of 230v and low voltage cables
▶ Prepare cables.
▶ Detach sealing nut ( Figure 53, [1]).
▶ Remove sealing grommet ( Figure 53, [2]).
▶ Pass cables through the cable gland and sealing grommet.
▶ Attach it to the PCB edge connectors.
▶ Re-attach the sealing nut ( Figure 53, [2]).
Fig. 53 Seal into the body
[1]
Sealing nut
0010042679-001
[2]
Sealing grommet
▶ Arrange cable length inside appliance
▶ Connect cable to related connector.
▶ Reapply seal nut.
▶ Carefully tighten seal nut by appropriate tool.
2
3
1
2
Greenstar 1000 – 6721835943 (2023/08)
4
0010042680-001
0010048736-001
Advertisement
Table of Contents
