Table of Contents
Advertisement
ART 5W/GTWIN MONITOR
MONITOR DESCRIPTION
Description of the configuration jumpers:
( )
*
JP1
Monitor with JP1 jumper place to right, takes the current from system power supply
(factory default).
Monitor with JP1 jumper place to left, takes the current from dedicated power supply
"1723/22".
( )
*
JP2
Monitor with JP2 jumper place to left, low power
Monitor with JP2 jumper place to right (High power) with use of dedicated power supply "1723/22".
( )
*
JP3
Monitor with JP3 jumper place to left, has the end of line connected
Monitor with JP3 jumper place to right, has the end of line disconnected.
( )
*
Factory default.
Function push buttons:
Monitor in standby mode: one short press it activates/ desactivates the "do not disturb" mode and the indicator
led will illuminate (red).
hours and the indicator
Monitor in standby mode: allows you to display the image from the main door panel, press the button
press the button
pressed again, the image of the secondary door panel will be displayed, in carousel mode. Then, if you press the
button
, you can establish audio and video communication with the selected door panel.
During a call process: it allows the secondary monitors (in the same apartment) to capture the door panel image,
with the image of the monitor that was displaying it disappearing.
Monitor in standby mode: it allows the intercom between 2 monitors of the same or different apartment (this function
must be programmed previously, (
apartment or a monitor in your apartment to be called with the help of the push buttons
push button
During call reception and communication or auto-spy processes, it enables the main lock release to be activated.
During call reception and communication or auto-spy processes, it enables the secondary lock release to be activated,
one press will activate the door release for 1 second.
Access to the configuration menu and function buttons: when the monitor is in standby mode 2 presses
accesses the configuration menu or 1 press accesses function buttons.
One press by
3 se
led
will blink ed
(r
(if the channel is busy, short acoustic tones on the monitor will indicate it), if the button
see pages
.
(factory default)
conds it activates
/ desactiva
).
15 16)). Press the button
-
( )
*
.
(factory default)
.
tes the "do not disturb" mode during 8
, then press the button
/
5
JP1
JP2
JP3
V-
V+
GND
SA
once, then
is
and select the
&
confirm with the
Advertisement
Table of Contents
