Jp3 End Of Line Jumper - golmar ART 5W/GTWIN User Manual

ART 5W/GTWIN MONITOR
MONITOR SETTINGS
SW2 configuration switch:
"INT"
The configuration switch is located at the back of the monitor. It enables the monitor to
INT
be configured as master/slave.
INT: Internal code of the monitor/telephone to set as master/slave.
Set the monitor/telephone as master, slave 1, slave 2 or slave 3 using
the INT switch with a code from 0 to 3 respectively. Taking into account the following points:
Ÿ In the case of a single monitor/telephone in the apartment, the code to be set will always be 0.
Ÿ In apartments, up to 4 monitors/telephones can be connected in parallel, all with the same user code but with
different internal monitor/telephone code.
Ÿ The internal code identifies each of the monitors/telephones in the same apartment. This enables intercom calls to
be made to a specific monitor/telephone in the same apartment. In the case of intercom calls to different
apartments, and in the case of calls coming from door panels and from apartment front doors, all of the
monitors/telephones in the apartment always sound. The following considerations must also be borne in mind:
Ÿ When master monitor/telephone 0 receives a call, it sounds immediately and slave monitors/telephones 1, 2 and 3
sound in succession, one after the other.
Ÿ If a call is made from a video door entry panel, master monitor 0 shows the image of the door panel. During the call
time (60 seconds) and before establishing communication, the other slave monitors in the same apartment can
capture the image of the door panel if button
to disappear.
( )
Factory setting.
*

JP3 end of line jumper:

JP3 end of line jumper,
where the bus cable end. Insert the jumper JP3 to the right only on the
JP3
Leave the JP3 jumper inserted on the left on those monitors where the bus
cable end (
JP3
Insert the jumper JP3 to the right only on the
line disconnected).
( )
*
is located at the back of the monitor
end of line connected)
is pressed, causing the image on the monitor that was displaying it
INT SWITCH:
ON ON ON ON
1 2 1 2 1 2 1
INT 0 INT 1 INT 2 INT 3
. Leave the JP3 jumper inserted on the left on those monitors
intermediate
.
intermediate
( )
*
2
monitors.
monitors. (end of
9
CODE INT
SW 1 SW 2
1 2 3 4 5 6 7 8 1 2
JP1
JP2
JP3
V-
V+
GND
SA