HIKVISION AP530HT Quick Start Manual page 25

2. Disassemble the speed dome.
1) Loosen three screws as shown in the following figure.
2) Remove the lower dome.
3) Loosen three screws and remove the back box.
4) Remove the protective lens cover, foam and sticker from the dome drive.
Back Box
3. Install the toggle bolts.
1) Remove the toggle from the toggle bolt.
2) Insert the bolts into the screw holes on the dome.
3) Rotate the bolts through the screw holes.
4) Reinstall the toggles as shown in Figure 2-15.
4. Align the toggle bolts with the screw holes on the ceiling.
5. Push the dome to the mounting hole on the ceiling.
HD-TVI Speed Dome·Quick Start Guide
Figure 2-13 Drill Holes
Figure 2-14 Disassemble the Speed Dome
Figure 2-15 Install the Toggle Bolts
19
Ф129
Ф11
Sticker
Toggle
Bolt
Protective Foam
Notch
Lower Dome