HIKVISION AP530HT Quick Start Manual page 23

1. Rotate the lower dome counterclockwise to separate it from the back box. Refer to the Figure
2-1.
2. Remove the protective lens cover, foam and sticker from the dome drive.
3. Set the address and baudrate for the analog speed dome. Please refer to the Section 1.2.1
5-inch Speed Dome Settings for DIP switch settings.
4. Attach lower dome to the back box, and rotate clockwise to secure it.
5. Use the mounting base as a template to mark four screw holes onto the ceiling.
6. If you route cables from the top of the back box, mark the cable hole on the ceiling and drill a
hole.
7. Secure the mounting base to the ceiling with set screws.
 If the speed dome is installed to the wooden wall, use the self-tapping screws to secure
the mounting base.
 If the dome is installed to the cement wall, drill three Φ5 mounting holes onto the wall
according to the hole locations, and then insert the cement screws into the holes and
finally use self-tapping screws to secure the mounting base to the wall.
8. Install the speed dome to the mounting base.
(1) Route the cables for the speed dome. Align the bottom of the speed dome with the
mounting base.
(2) Line up the direction of arrow with the spring end of the mounting base.
(3) Push the speed dome upwards and then forwards in the direction of arrow. When the speed
dome is placed in position, the spring will automatically snap into the lock clip firmly. Refer
HD-TVI Speed Dome·Quick Start Guide
Figure 2-10 Mark the Screw Positions
Screw Holes
Cable Hole
Figure 2-11 Secure the Mounting Base
17