5-Inch Ir Speed Dome Settings - HIKVISION AP530HT Quick Start Manual

Baudrate Settings
The number 1 and 2 SW2-switches are used for setting the baudrate of the speed dome. The
baudrate can be 2400bps, 4800bps, 9600bps and 19200bps. The baudrate will be set as 2400bps by
default if it is out of this range. Refer to the following table:

1.2.2 5-inch IR Speed Dome Settings

The DIP switch is for setting the speed dome address, baudrate, protocol, etc., with value ON=1 and
OFF=0. The switch label is on the back of the SWITCH cover as shown in Figure 1-6.
Figure 1-6 Position of DIP Switch for 5-inch IR Speed Dome
 For some certain models, the two individual DIP switches at the left side of the Figure 1-7 are
supported for turning on/off the terminator; while other models are not supported.
HD-TVI Speed Dome·Quick Start Guide
Table 1-4 Set the Baudrate of the Dome
Switch No.
Baudrate
2400
4800
9600
19200
Screws
ON
ON
1 2 1 2 3
Figure 1-7 Enlarged View of DIP Switch
4
1 2
OFF OFF
ON OFF
OFF ON
ON ON
DIP Switch
DIP
4 5 6 7 8 9 10
Switch Cover