Table of Contents
Advertisement
Note:
• The default remote code is "*90" which can be modified by users through "Fax"-
"Fax setting"-"Receive set."-"Remote code".
• Received fax job may not be printed in case of low cartridge, please renew
cartridge or turn "Continue to print in low cartridge" function on in fax receiving
setting.
10.3.3. Set the compatibility of interference VoIP telephone line
If the fax is sent or received abnormally due to interference to telephone line, please improve
the fax receiving and sending with the following methods.
1. Switch to VOIP Compatible mode with panel setting.
Please follow steps below to set :
1. Click "Fax" button in control panel, then click "Setting" button to enter "Fax setting"
interface.
2. To shift to VoIP compatible mode, click "General setting-Compatibility", select "VoIP".
3. Try to resend the fax in off-peak hours.
4. Consult your VoIP provider on if the network setting on fax transmission could be
optimized.
10.3.4.Other Fax Functions
1. Group Sending
This printer supports sending one original to several fax numbers, with the ability of up to 20
fax numbers sent to at the same time.
2. Delay Sending
You can enable Delay sending of Fax through the Control Panel. When this process is
complete, the printer will scan the document to the memory, and get back to Ready state.
3. Active Job
You may check or delete the delay sending jobs stored currently with the "Active Job" menu.
4. Receive and forward
Fax may be forwarded. Forwarding fax to another fax or designated Email address is
supported.
1) Forward to Fax
Select "Fwd to fax", input and confirm receiver's Fax No. When fax job is received, the
product will dial preset Fax No. and forward the fax job. If forwarding fails due to line
occupation, faults and other causes, the forwarded content will be automatically printed in
one copy for backup (If re-dial is set, it prints after re-dial).Select "Fwd & Print", to enable
auto printing of all forwarded to fax.
80
Advertisement
Table of Contents
Troubleshooting
