Table of Contents
Advertisement
22
GETTING TO KNOW YOUR VEHICLE
4. Fit a new battery ensuring that the positive (+) side
is facing upwards. Push the battery into the pocket
until it is firmly seated in place and secured under
both tabs.
5. Align the back cover into its original position and
snap it back in place by pushing it against the fob
until it is seated all around.
WARNING!
•
The integrated key fob contains a coin cell battery.
Do not ingest the battery; there is a chemical burn
hazard. If the coin cell battery is swallowed, it can
cause severe internal burns in just two hours and
can lead to death.
•
If you think a battery may have been swallowed or
placed inside any part of the body, seek immediate
medical attention.
•
Keep new and used batteries away from children.
If the battery compartment does not close
securely, stop using the product and keep it away
from children.
Programming And Requesting
Additional Key Fobs
Programming the key fob may be performed by an
authorized dealer.
NOTE:
•
Once a key fob is programmed to a vehicle, it cannot
be repurposed and reprogrammed to another
vehicle.
•
Only key fobs that are programmed to the vehicle
electronics can be used to start and operate the
vehicle.
WARNING!
•
Always remove the key fobs from the vehicle and
lock all doors when leaving the vehicle
unattended.
•
For vehicles equipped with Keyless Enter 'n Go™
Ignition, always remember to place the ignition in
the OFF position when exiting the vehicle.
Duplication of key fobs may be performed at an autho-
rized dealer. This procedure consists of programming a
blank key fob to the vehicle electronics. A blank key fob
is one that has never been programmed.
NOTE:
•
When having the Sentry Key Immobilizer system
serviced, bring all vehicle keys with you to an autho-
rized dealer.
•
Emergency keys must be ordered to the correct key
cut to match the vehicle locks.
•
It is not mandatory to replace the key fob if a new
emergency key is needed, and vice versa.
SENTRY KEY
The Sentry Key Immobilizer system prevents unauthor-
ized vehicle operation by disabling the engine. The sys-
tem does not need to be armed or activated. Operation
is automatic, regardless of whether the vehicle is
locked or unlocked.
The system uses a key fob, keyless push button ignition
and a Radio Frequency (RF) receiver to prevent unau-
thorized vehicle operation. Therefore, only key fobs that
are programmed to the vehicle can be used to start and
operate the vehicle. The system cannot reprogram a
key fob obtained from another vehicle.
After placing the ignition in the ON/RUN position, the
Vehicle Security Light will turn on for three seconds for
a bulb check. If the light remains on after the bulb
check, it indicates that there is a problem with the elec-
tronics. In addition, if the light begins to flash after the
bulb check, it indicates that someone attempted to
start the engine with an invalid key fob. If a valid key fob
is used to start the engine but there is an issue with the
vehicle electronics, the engine will start and shut off
after two seconds.
If the Vehicle Security Light turns on during normal
vehicle operation (vehicle running for longer than
10 seconds), it indicates that there is a fault in the elec-
tronics. Should this occur, have the vehicle serviced as
soon as possible by an authorized dealer.
CAUTION!
The Sentry Key Immobilizer system is not compatible
with some aftermarket Remote Start systems. Use of
these systems may result in vehicle starting problems
and loss of security protection.
All of the key fobs provided with your new vehicle have
been programmed to the vehicle electronics
page 318.
NOTE:
A key fob that has not been programmed is also consid-
ered an invalid key.
Advertisement
Table of Contents
