Sentry Key; Customer Key Programming; Replacement Keys; Vehicle Security Alarm - If Equipped - Chrysler 300 2017 Owner's Manual

SENTRY KEY

The Sentry Key Immobilizer System prevents
unauthorized vehicle operation by disabling the
engine. The system does not need to be armed
or activated. Operation is automatic, regardless
of whether the vehicle is locked or unlocked.
The system uses key fobs that have an embed-
ded electronic chip (transponder) to prevent
unauthorized vehicle operation. Therefore, only
key fobs that are programmed to the vehicle can
be used to start and operate the vehicle. The
system will shut the engine off in two seconds if
someone uses an invalid key to try to start the
engine.
NOTE:
A key fob that has not been programmed is also
considered an invalid key, even if it is cut to fit
the ignition or lock cylinder for that vehicle.
During normal operation, after placing the igni-
tion in the on position, the vehicle security light
will turn on for three seconds for a bulb check. If
the light remains on after the bulb check, it
indicates that there is a problem with the elec-
tronics. In addition, if the vehicle security light
begins to flash after the bulb check, it indicates
that someone used an invalid key to try to start
the engine. Either of these conditions will result
in the engine being shut off after two seconds.
If the vehicle security light turns on during
normal vehicle operation (vehicle running for
longer than ten seconds), it indicates that there
is a fault in the electronics. Should this occur,
26
have the vehicle serviced as soon as possible
by an authorized dealer.
CAUTION!
The Sentry Key Immobilizer system is not
compatible with some aftermarket remote
starting systems. Use of these systems may
result in vehicle starting problems and loss of
security protection.
All of the key fobs provided with your new
vehicle have been programmed to the vehicle
electronics.

Customer Key Programming

Programming key fobs may be performed at an
authorized dealer.

Replacement Keys

NOTE:
Only key fobs that are programmed to the
vehicle electronics can be used to start and
operate the vehicle. Once a key fob is pro-
grammed to a vehicle, it cannot be programmed
to any other vehicle.
CAUTION!
• Always remove the key fobs from the ve-
hicle and lock all doors when leaving the
vehicle unattended.
CAUTION! (Continued)
• For vehicles equipped with Keyless Enter-
N-Go — Ignition, always remember to
place the ignition in the OFF position.
NOTE:
Duplication of key fobs may be performed at an
authorized dealer. This procedure consists of
programming a blank key fob to the vehicle
electronics. A blank key fob is one that has
never been programmed.
When having the Sentry Key Immobilizer Sys-
tem serviced, bring all vehicle keys with you to
an authorized dealer.
VEHICLE SECURITY ALARM —
IF EQUIPPED
The vehicle security alarm monitors the vehicle
doors for unauthorized entry and the keyless
push button ignition for unauthorized operation.
While the vehicle security alarm is armed, inte-
rior switches for door locks and trunk release
are disabled. If something triggers the alarm, the
vehicle security alarm will provide the following
audible and visible signals: the horn will pulse,
the park lamps and/or turn signals will flash, and
the vehicle security light in the instrument clus-
ter will flash.
(Continued)